polarsign

This installation of TCS M4 Decoder is for HO Scale ROCO 4154 BR290 and was performed by Ric Bogart of Osborne Park W A, Australia Important Soldering Tip: Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. We recommend to use only Kester '44' rosin core, SN63PB37,.015' diameter, part number 24-6337-0007. This can be ordered from Techni-Tool under Techni-Tool part number 488SO157 Although this is a fairly large diesel there is very little room inside this model. Los Caballeros Del Zodiaco Para Psp Iso on this page. I had intended to install a T1 decoder but it was about 2mm to long. A TCS M4 was used instead.

Roco Model Railway Product Decoders. Ashrae Cooling And Heating Load Calculation Manual Grp 158. My profile; Login; English. Zuma Deluxe 1.0 0.1 Crack. 6-pin decoder, straight pins (NEM 651). Digital coupler installation kit (NEM 652) Art.

A M1 decoder could be used as well. First, remove the cover off the loco (as per the operating instructions for the service of the unit) Lift the locomotive casing and remove. 2.At this point the original wiring and components can be unsoldered.Removing the diodes isolates the lights from one side of the track power pickup. Removing the RF chokes isolates the motor. 3.Following the decoders instructions the red wire -----to the right side rail pickup orange wire -----to the motor circuit where the choke was black wire ---- to the left side rail pickup grey wire ------to the motor circuit where the choke was ----- yellow to the rear headlight -------white to front headlight (the lights were connected in half wave mode powered from the track).